The CoilArt Lux 200 Kit is a new release including the Lux 200 mod and the Lux Mesh Sub Ohm tank.
The Lux mod will output up to 200W and you will require 2×18650 batteries to power it.
The design on the black and white versions replicates a marble slab! The other colours are a bit more “abstract”. Apparently the styling was aided by an Italian fashion designer – Aligheri Petraca. CoilArt wanted to change the way mods usually look.
To achieve this vibrant styling the side panel is made from reinforced glass which has a UV printing layer.
There are Variable Wattage and temperature control (Ti, Ni, SS) modes to keep you amused.
The firmware is upgradeable and the Eagle chipset means with the correct software you can hook up the mod to a PC, Laptop etc and customise all the settings and display too.
Included in the full kit is the Lux Mesh tank – which has a similar finish to the mod it is paired with.
Image courtesy of Heavengifts.com
The tank uses the M1 and M4 mesh coil heads which are both included in the kit.
Image courtesy of Heavengifts.com
The tank is a top filling design with bottom adjustable airflow.
There are 5 versions to choose from – Black, White, Blue, Green and Red.
KIT INCLUDES
- CoilArt Lux 200 Mod
- CoilArt Lux Mesh Tank
- Spare glass
- M1 coil (pre-installed)
- M4 coil
- USB Cable
- User manual
COILART LUX 200 MOD SPECS
- Size: 53x25x89mm
- Battery: 2×18650 (not included)
- Output: 5-200W
- Output modes: VW, TC (Ni, Ti, SS)
- Resistance range: 0.05-3ohm
- Temperature range: 95-315°C / 200-600°F
- Reinforced glass side panel with UV printing
- Self adjusting battery contact
- Firmware upgradeable
Image courtesy of Heavengifts.com
COILART LUX MESH TANK SPECS
- Size: 24x50mm
- Capacity: 5.5ml
- Coils: 0.15ohm M1 coil, 0.15ohm M4 coil
- Faux Marble resin styling
- Slide top fill
- Adjustable bottom airflow
- 810 drip tip
Image courtesy of Heavengifts.com
This is a really striking looking kit isn’t it! Those panels do look great!
